talon-tools

Getting Started

Quick Guide to Setup Wireless Gigabit Links

Download and fetch our latest lede image for the Talon AD7200 from our releases.
Follow the instructions to flash the image on one device.
Connect to the device ‘ssh 192.168.0.1’ and change the IP address:
```
ifconfig eth1 192.168.0.2
```
Connect again using the new address ‘‘ssh 192.168.0.2’ and configure it as access point and start the iperf server
```
ifconfig wlan2 192.168.100.2
hostapd -B /etc/hostapd_wlan2.conf
iperf3 -s
```
Flash your second device
Connect to the device ‘ssh 192.168.0.1’ and start iperf in client mode
```
iperf3 -c 192.168.100.2
```

You should see a performance similar to the following:

[SUM]   0.00-10.00  sec  2.27 GBytes  1.95 Gbits/sec    0             sender
[SUM]   0.00-10.00  sec  2.27 GBytes  1.95 Gbits/sec                  receiver

This site is open source. Improve this page.